煤粉罐车卸料速度影响因素研究Influencing factors of pneumatic conveying efficiency of coal powder tank car
张鑫,刘振宇,李小炯,李婷
ZHANG Xin,LIU Zhenyu,LI Xiaojiong,LI Ting
摘要(Abstract)：
为解决工程实践中煤粉罐车向煤粉塔气力送粉时间过长的问题,对输送阻力进行了计算,并对煤粉罐车的卸料速度影响因素进行了分析。结果表明:上粉管的压力损失由两相流摩擦压损、煤粉颗粒重力压损以及煤粉颗粒加速动力压损3部分构成。当煤粉塔高度由23 m变为28 m时,同样输送20 t煤粉所需时间由50.0 min延长到58.5 min,延长了17%,若保证输送时间不变,则输送管内径应由100 mm增至106 mm,此数据与实际仍有较大偏差,这是由于管道内存在其他阻力因素或煤粉水分较高导致。因此,为保证良好的输送效果,建议采用锅炉房或厂区内的洁净干燥压缩空气作为上粉输送气体。
To minimize the conveying time from coal powder tanker to tower,calculated the resistance during conveying. Analyzed the influencing factors of unloading speed of coal powder tank car. The results show that,the pressure loss of conveying pipe consists of two-phase flow friction pressure loss,coal powder gravity pressure loss and accelerated dynamic pressure loss. When the height of silo increases from23 m to 28 m,the conveying time of 20 tons coal powder delays from 50 min to 58. 5 min,by 17%. Keep the conveying time unchanging,the inner diameter of pipe should increase from 100 mm to 106 mm which is different from the actual situation. The possible reasons are resistance of pipe or high moisture of coal powder. To guarantee the better conveying effects,the clean,dry and compressed air in boiler room or plant should be used as powder conveying gas.
关键词(KeyWords)：
煤粉;罐车;煤粉塔;输送;阻力
coal powder;tank car;coal powder tower;convey;resistance
基金项目(Foundation): 国家国际科技合作专项资助项目(2012DFA60860);; 中煤科工集团技术创新基金资助项目(2013QN035)
作者(Author):
张鑫,刘振宇,李小炯,李婷
ZHANG Xin,LIU Zhenyu,LI Xiaojiong,LI Ting
DOI: 10.13226/j.issn.1006-6772.2014.05.022
参考文献(References)：
- [1]何海军,纪任山,王乃继.高效煤粉工业锅炉系统的研发与应用[J].煤炭科学技术,2009,37(11):1-4.
- [2]韩万喜.散装水泥运输车吹卸效率探究[J].专用汽车,2003(1):15-16.
- [3]张洪波,田娟.散装水泥车平均卸料速度和剩余率的研究[J].商用汽车,2003(1):53-54.
- [4]孟庆敏,周云,陈晓平,等.粉体密相气力输送研究综述[J].锅炉技术,2011,42(3):1-5.
- [5]GB 50607—2010,高炉喷吹粉煤工程设计规范[S].
- [6]张海涛.粉体气力输送计算中的几个问题的讨论[J].化工设备与管道,2002,39(4):13-17.
- [7]林江.气力输送系统流动特性的研究[D].杭州:浙江大学,2004.
- [8]林江,林建忠,楼建勇,等.气力输送系统中初始气固速度比对固粒输送速度的影响[J].煤矿机械,2003(8):35-37.
- [9]吴晓.栓流密相气力输送特性的试验研究[J].硫磷设计与粉体工程,2009(1):13-17.
- [10]黎晖.流化床式水泥罐车卸灰过程分析[J].铁道车辆,1993(7):33-34.
- [11]郑镭.散装水泥运输车的优化分析[D].唐山:河北理工大学,2008.
- [12]朱军.立式和卧式散装水泥下灰罐车的设计问题[J].石油矿场机械,1996,25(4):2-4.
- [13]李仲山,颜福高,朱文.重力举升式粉罐车远距离低速密相输送分析[J].专用汽车,2004(4):29-30.
- [14]高景华,胡建波.罐车运输粉状或颗粒状物料气力卸料及输送装置[J].矿业工程,2011,9(6):63-64.
- [15]李志义,周一卉,由宏新.粉体的气力输送[J].硫磷设计与粉体工程,2000(1):12-13.